15
Dec
2008
Bonsai of Cotoneaster
Bonsai
0
0

Propagation by seeds. Add fruit is mature and let it dry, mixing it occasionally. To stratify seeds in the sand until January, after which the plants in the ground, covered with peat. Germinate after three months.

Propagation is by cuttings in summer, under glass, perisitente leaf species, from June to July for deciduous species, rooting takes place in six weeks. Substrate must be a mixture of 1/3 garden soil, 1/3 peat and sand, 1/3 mranita. Cut the branches the following spring, when transvazarii.

Bonsai can be obtained and the young plants in the greenhouse.

Cotoneaster prefer places in full sun but can grow in semi-shade locations.

It protjeaza lower temperature -3 °C, withstand heat well.

Support wind.

The vessel is the ideal medium deep, smaltuit or not, but needs good drainage.

To remove dead leaves and fruit wines. If shrub is too infrutescente, some are abolished to avoid fatigue.

Grows quite fast in first years, then slow down.

Adapters are made each year, before dezmugurire, cut 1/3 of roots and is transplanteaza a larger vessel than the last.

Indicated substrate is composed of mranita ¼, sandy soil garden and bad. Cotoneaster thrive on fertile land and rich siliceous clay-humus, bear dry land and trails.

In June of us are reduced to two buds and shoots in September cut the branches too elongated.

Cutting branches is in March, before inatrarea in vegetation during transplantation.

Binding of trunk and branches is made before bud emergence, protecting the bark with raffia.

The wet aboundnight, but the land is let it dry thoroughly between watering.

Spring and autumn manages organic fertilizer with slow absorption. If necessary enriched with phosphate. Occur when fruits are given liquid fertilizer.

See also
Top
Bonsai
Bonsai of Syringa vulgaris

Propagation by cuttings is spring, the basal bark of seedlings is clean and is placed in a mixture of sand and peat and keep it warm.

Syringa vulgaris blooms better in full sun and tolerates partial semiumbra. Suffer from strong frosts. Support wind if not continuously.

 
Bonsai Bambusa ventricosa and Bambusa multiplex

It can multiply by dividing rhizomes. Choose knotty rhizomes close horizontal. The leaves of a bud and two years full radacilnile after a anmugurele be eliminated if others appeared in November. Spring planting, before the appearance of new buds in deep pots with soil moisture.

They need plenty of light and hot-wet environments all year, the temperature does not fall below 19 ° C.

 
Multiplication by obtaining seedlings for bonsai

This type of breeding consists in planting directly in soil or after a period of immersion in water, a part of the plant.

Prepare a Butas: peplanta stalk the mother must cut immediately after the insertion of leaves, cut apical parts.

 
Multiplication by obtaining seeds for bonsai

Multiplication through seeds is a difficult method but give spectacular results.

The seeds can be taken from other plants or bonsai from normal plants, collected in the fall directly on the plant.

Germ Conditions are different for each type of seeds.

 
Bonsai of Crassula arborescens

Mid spring, prepare seedlings of 10 cm, let it dry in the sun for 3 days, then planting a mixture of peat and sand 1:1, without watering. After several days, moisten slightly. When roots appear abundantly moisten but not soak the soil with water.

 
Comments
Top
comments powered by Disqus
   Add to iGoogle
Last posts

Categories

Links