05
Nov
2008
Correct location bonsailor
Bonsai
0
0

Light. Formed from bonsai trees adapted to our climate, have normal demands of growing trees normally in nature: some species prefer sunny exhibitions, others prefer semiumbra. Finctie bonsai species in the apartment were various demands towards the light. However, all fleeing bonsai direct sun and warm air flows.

Temperature. Bonsai growing outdoor stagione follow cycles of vegetation. In cases where the risk of frost bonsai can be inserted inside. In any case should not be left, inside, more than three days in winter. Trees with leaves fell, if they stay more than three days in heat, they start forming buds. An artificial spring would be fatal for bonsai. The bigger the temperature difference between outside and inside with the greater danger of TRANSLOC plant inside. In winter, when temperature is below 0 ° C, the dish is better wrapped in paper, wool or dry leaves.

Ventilation. Outdoor bonsai, adapted to our climate, easy withstand the effects of wind, for some species, a position cores, especially in winter, it is desirable to adjust the tree so as to avoid the phenomenon of dehydration.

The ship is not only an essential object, but has a decorative effect.

Material. Tradition requires that the vessel be ceramic or plaster. To preserve the wall porosity is good that even the inside was not enameled.

Color and decorations depend on the type of vessel tree. It is good to find a connection between the tree and decorations. Otherwise, it would impair the elegant tree decorations.

Vessel dimensions. A ship too far does not allow root dabsorbii it all the water from the ground, there is risk of molds. A vessel too small lead to atrophy roots. Length of the vessel must be 2 / 3 of bonsai tree height.

Type of vessel is chosen depending on the type of bonsai: a driven shaft as the waterfall should be placed in deep dishes, round, square or hexagonal.

See also
Top
Bonsai
Pinus mugo bonsai

Pinus mugo seeds for propagation by strobili gather in December, are preserved in a cold and shady. The half of April to stratify the pregerminare, germination takes place after two months.

Propagation by cuttings is little used because it needs very long time.

 
Types of Bonsai

Bonsai is a miniature tree grown in pot.

The word bonsai is Japanese, and his bon-means tree in pot.

Mini-bonsai, measured from 5 cm to 15 cm. They are only demanding more work because of its small size.

 
Multiplication by obtaining seeds for bonsai

Multiplication through seeds is a difficult method but give spectacular results.

The seeds can be taken from other plants or bonsai from normal plants, collected in the fall directly on the plant.

Germ Conditions are different for each type of seeds.

 
Bonsai of Syringa vulgaris

Propagation by cuttings is spring, the basal bark of seedlings is clean and is placed in a mixture of sand and peat and keep it warm.

Syringa vulgaris blooms better in full sun and tolerates partial semiumbra. Suffer from strong frosts. Support wind if not continuously.

 
Comments
Top
comments powered by Disqus
   Add to iGoogle
Last posts

Categories

Links