Multiplication by obtaining seeds for bonsai
Multiplication through seeds is a difficult method but give spectacular results.
The seeds can be taken from other plants or bonsai from normal plants, collected in the fall directly on the plant.
Germ Conditions are different for each type of seeds. Some seeds can be sown immediately after collection, as in the degree to germinate quickly. Others must be kept in ventilated and cool place before being seeded. Spring and late summer-early fall are two moments favorable for seeding.
It takes a vessel with perforated bottom to allow excess water to scurga.se filled with 50% peat and 50% of river gravel. Fill three-fourths of the vessel only, without pressing the earth so that water can circulate air and you have prepared substrate usor.Dupa shall seed is covered with earth, presarand easy, then moisten thoroughly. Finally it covers the dish with a glass and placed in the shade and protected from frost.
Once the glass is moving primimuguri gave little for air movement to adapt to new seedlings and the temperature outside has finally appeared when leaflet.
In the spring, when all seeds have sprung, is transplanteaza each seedlings in another vessel which will gradually adjust to sunlight. About two years after the start of lead in bonsai plant, cutting and branches (spring and summer) and roots (spring).
Bonsai of Syringa vulgaris
Propagation by cuttings is spring, the basal bark of seedlings is clean and is placed in a mixture of sand and peat and keep it warm.
Syringa vulgaris blooms better in full sun and tolerates partial semiumbra. Suffer from strong frosts. Support wind if not continuously.
Pinus mugo bonsai
Pinus mugo seeds for propagation by strobili gather in December, are preserved in a cold and shady. The half of April to stratify the pregerminare, germination takes place after two months.
Propagation by cuttings is little used because it needs very long time.
Multiplication by obtaining seedlings for bonsai
This type of breeding consists in planting directly in soil or after a period of immersion in water, a part of the plant.
Prepare a Butas: peplanta stalk the mother must cut immediately after the insertion of leaves, cut apical parts.
Bonsai Bambusa ventricosa and Bambusa multiplex
It can multiply by dividing rhizomes. Choose knotty rhizomes close horizontal. The leaves of a bud and two years full radacilnile after a anmugurele be eliminated if others appeared in November. Spring planting, before the appearance of new buds in deep pots with soil moisture.
They need plenty of light and hot-wet environments all year, the temperature does not fall below 19 ° C.
Types of Bonsai
Bonsai is a miniature tree grown in pot.
The word bonsai is Japanese, and his bon-means tree in pot.
Mini-bonsai, measured from 5 cm to 15 cm. They are only demanding more work because of its small size.